Display 11D24—Owner’s ManualC CounterThe main counter shows the current position inhours, minutes, seconds, and frames,(00:00:00.00), and can display the absolute(ABS) time or relative (REL) time. See “UsingAbsolute & Relative Zero” on page 49 for moreinformation.The 2nd line of the message area displays timeinformation in hours, minutes, seconds, frames,and sub-frames (00:00:00.00.0). Each sub-frameis one tenth of a frame, making 10 sub-framesper frame.The 2nd line is also used to display the remaining recording time. See “Checking theTime Remaining” on page 38 for more information.D READY indicatorsThese indicators show which tracks are selected for recording. When a track is selectedfor recording, the corresponding READY indicator flashes. During recording orrehearsal, the corresponding indicator lights up continuously. See “Recording” on page33 for more information.E Message areaThe message area consists of two lines that can each display up to 12 characters, whichtypically show the status and operating mode of the D24, function and parameternames and values, project titles and numbers, locate memory numbers, editing infor-mation, time values, and so on.F LOCK indicatorThis indicator shows whether or not the D24 is locked to the selected wordclock source.See “Selecting a Wordclock Source” on page 124 for more information.G CHASE indicatorThis indicator shows whether or not the D24 is synchronized to the external timecodesource. It flashes when the D24 is chasing, and lights up continuously when it’s fullysynchronized. See “Chasing External Timecode” on page 138 for more information.H WC windowThis window shows the selected wordclock source: internal (INT) or external (EXT).See “Selecting a Wordclock Source” on page 124 for more information.I BIT windowThis window shows the selected recording resolution: 16, 20, or 24. See “Setting theRecording Resolution” on page 32 for more information.J FS windowThis window shows the selected sampling rate: 44.1 kHz, 48 kHz, 88.2 kHz, or 96 kHz.When 88.2 kHz is selected, both the 44.1 kHz and 96 kHz indicators light up. See“Selecting a Wordclock Source” on page 124 for more information.The “VARI” indicator lights up when the Varispeed function is turned on. See “UsingVarispeed” on page 55 for more information.K TC windowThis window shows the selected timecode source: master or slave. When set to master,the D24 uses internal timecode, and when set to slave, an external timecode source. See“Selecting a Timecode Source” on page 135 for more information.H M S FS T O P0 0 0 0 0 0 0 0 00 0 0 0 0 0 0 0Hour Min Sec fr sub-frHour Min Sec fr
