Yamaha 2012 TMAX XP500A Service Manual

Also see for tmax XP500A: Owner's manual Owner's manual Owner's manual Owner's manual Service manual

Contents

IMMOBILIZER SYSTEM8-79Standby mode:To enable the immobilizer system, set the ignition key to “OFF”. 30 seconds later, the indicator lightwill start flashing continuously in the standby flashing mode pattern for up to 24 hours. After thattime, the indicator light will stop flashing, but the immobilizer system is still enabled.Standby modeStandard key registration:Standard key registration is required when a standard key is lost and needs to be replaced, or whenthe code re-registering key is re-registered after the immobilizer unit or ECU are replaced.TIPDo not start the engine with a standard key that has not been registered. If the main switch is set to“ON” with a standard key that has not been registered, the immobilizer system indicator light flashesto indicate fault code “52”. (Refer to “SELF-DIAGNOSIS FAULT CODE INDICATION” on page 8-82).1. Check that the immobilizer system indicator light signals the standby mode.2. Using the code re-registering key, set the main switch to “ON”, then “OFF”, and then remove thekey within 5 seconds.3. Insert the first standard key to be registered into the main switch, then set the key to “ON” within5 seconds to activate the key registration mode.TIPThe existing standard key code is erased from the memory when the key registration mode is acti-vated. When the key registration mode is activated, the immobilizer system indicator light flashesrapidly.4. While the indicator light is flashing, set the main switch to “OFF”, remove the key, and within 5seconds, insert the second standard key to be registered into the main switch.TIPIf he immobilizer system indicator light stops flashing 5 seconds after the first standard key is regis-tered, the registration mode is deactivated. If this occurs, the second standard key cannot be regis-tered, and steps 2 to 4 need to be repeated to register both standard keys.5. Set the main switch to “ON”.TIPWhen the indicator light goes off, the registration is complete.6. Check that the engine can be started with the two registered standard keys.a. Main switch “ON”b. Main switch “OFF”c. LED ond. LED offe. Standby mode onf. Standby mode off