Basic components19NOTE:After the main switch is first turned on, allsegments of the display come on as a test.After a few seconds, the gauge will changeto normal operation. Watch the gauge whenturning on the main switch to make sure allsegments come on.NOTE:The speedometer displays km/h, mph, orknots, according to operator preference. Se-lect the desired unit of measurement by set-ting the selector switch on the back of thegauge. See the illustration for settings.EMU26610Trim meterThis gauge shows the trim angle of your out-board motor.NOTE:Memorize the trim angles that work best foryour boat under different conditions. Adjustthe trim angle to the desired setting with thepower trim and tilt switch.EMU26620Trim meter (digital type)This meter shows the trim angle of your out-board motor.NOTE: Memorize the trim angles that work bestfor your boat under different conditions.Adjust the trim angle to the desired usingthe power trim and tilt switch. If the trim angle of your motor exceeds thetrim operating range, the top segment onthe trim meter display will blink.1. Speedometer2. Fuel gauge3. Trip meter/clock/voltmeter4. Warning indicator(s)1. Cap2. Selector switch (for speed unit)3. Selector switch (for fuel sensor)ZMU04581
