A.16 Control Mode Dependent Parameter Default ValuesThe tables below list parameters that depend on the control mode selection. Changing the control mode initializes theseparameters to the values shown here.u A1-02 (Motor Control Mode) Dependent ParametersTable A.3 A1-02 (Motor Control Mode) Dependent Parameters and Default ValuesNo. Name Setting Range Resolution Control Modes (A1-02)V/f (0) OLV/PM (5)b3-08 Current Control Gain during Speed Search (SpeedEstimation Type) 0.00 to 6.00 0.01 <1> 0.30C2-01 S-Curve Characteristic at Accel Start 0.00 to 10.00 0.01 s 0.20 1.00C4-01 Torque Compensation Gain 0.00 to 2.50 0.01 1.00 0.00C4-02 Torque Compensation Primary Delay Time 0 to 60000 1 ms 200 100C6-02 Carrier Frequency Selection 1 to 9; A to F 1 <1> 2E1-04 Maximum Output Frequency 40.0 to 240.0 0.1 Hz <2> 60.0E1-05 Maximum Voltage 0.0 to 733.1 0.1 V <2> 200.0E1-06 Base Frequency 0.0 to 240.0 0.1 Hz <2> 60.0E1-09 Minimum Output Frequency 0.0 to 240.0 0.1 Hz <2> 3.0L1-01 Motor Overload Protection Selection 0, 1, 4 1 1 4L3-20 DC Bus Voltage Adjustment Gain 0.00 to 5.00 0.01 1.00 0.65L8-38 Carrier Frequency Reduction Selection 0 to 2 1 <1> 0L8-40 Carrier Frequency Reduction Off-Delay Time 0.00 to 2.00 0.01 s 0.50 0.00<1> Default setting is dependent on parameter o2-04, Drive Model Selection.<2> Default setting is dependent on parameter E1-03, V/f Pattern Selection.A.16 Control Mode Dependent Parameter Default ValuesYASKAWA SIEP YAIZ1U 03B YASKAWA AC Drive – Z1000 Programming Manual 239A Parameter List
