OneStart

Menu

YASKAWA SGDH Sigma II Instructions Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Contents
  1. Table Of Contents
  2. Table Of Contents
  3. general precautions
  4. SYMBOLS FOR SAFE OPERATION
  5. NOTES FOR SAFE OPERATION
  6. warning label
  7. PART
  8. Appearance and Nameplate
  9. Mounting FC100 Unit
  10. INSTALLATION
  11. Orientation
  12. WIRING
  13. OPERATION
  14. Precautions at Operation
  15. MEASURES TO SATISFY THE EMC DIRECTIVE
  16. Cable Clamp
  17. Wiring Examples
YASKAWA SGDH Sigma II Instructions Manual Manual pdf 11 page image
2 CHECKING ON DELIVERYE - 82.4 Mounting FC100 UnitMount a FC100 Unit on a SGDH SERVOPACK in the following manner. Provide the screwsfor connecting ground wire as shown below.MountingMethod SERVOPACK Type Screw RemarksBasemountedSGDH-A3 to 02BESGDH-A3 to 10AEM3×10 round head screws(with spring washer andplain washer)Attachments.SGDH-15 to 50AESGDH-05 to 30DEM4×10 round head screws(with spring washer andplain washer)Attachments.SGDH-60/75AE M4×8 round head screws(with spring washer andplain washer)Use the screw of the front panel.RackmountedSGDH-A3 to 02BE-RSGDH-A3 to 50AE-RSGDH-05 to 30DE-RM4×6 round head screws(with spring washer andplain washer)Attachments.Note : Make sure that spring washers andplain washers are used for mounting.(Otherwise, the screw for connectingground wire sticks out from the otherside of the flange, and the SERVO-PACK cannot be mounted properly.)DuctventilatedSGDH-60/75AE-P M4×8 round head screws(with spring washer andplain washer)Use the screw of the front panel.1. Remove the connector cover mounted on CN10 of SERVOPACK.MODE/SET DATA/CHARGE POWERSGDH−SERVOPACKYASKAWACN10Connectorcover2. Mount a FC100 Unit.SGDH−SERVOPACKYASKAWAF 1C 00CN4CN10Connector (to SERVOPACK)
/ 21
This manual is suitable for:
SGDH Sigma II
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved