Xterra FS380 ELLIPTICAL Owner's Manual

Also see for FS380 ELLIPTICAL: Owner's manual

Contents

Xterra FS380 ELLIPTICAL Owner's Manual Manual pdf 14 page image

FS380 Elliptical1141. Take 2 of Slide Wheel Covers (68) and 2 of the Phillips Head Screws(84) and use the Phillips Head Screw Driver (120).2. Attach the front (69) and rear (70) handle bar covers together on the leftswing arm shaft and use 3 Sheet Metal Screws (86) and secure withPhillips Head Screw Driver (120). Repeat on the right side on handle barcovers (71) and (72).3. Hammer 4 Oval End Cap (45) into Main Frame 4 corner by plastichammer.Plastic Covers4Plastic Covers1. Install the 2pcs of Slide Wheel Covers (68) and the 2pcs of M5 × 15mm_Phillips HeadScrews (84) by using the Phillips Head Screw Driver (120).2. Attach front (69) and rear (70) handle bar covers together on left swing arm shaft anduse three 3.5 × 12m/m_Sheet Metal Screws (86) to secure with Phillips Head ScrewDriver (120). Install them the way for the right side on handle bar covers (71) and (72).3. Knocked 4 Ø40 × Ø80_Oval End Cap(45) into Main Frame 4 corner by plastic hammer.#84. M5 x 15mmPhillips Head Screw(4 pcs)#86. 3.5 x 12mmSheet Metal Screw(6 pcs)Hardware Step 4