BAGS11.135 2460 PIVOT BALL 5.8 (10)35 8010 COMPOSITE FRAME SHOCK PARTS35 8011 COMPOSITE SHOCK ADJUSTABLE CLIPS35 8035 SHOCK PISTON SET (2)35 8050 ALU SHOCK CAP NUT (2)35 8070 SHOCK BOOT (4)35 8080 SHOCK RUBBER MEMBRANE (4)35 8095 XRAY SPRING-SET SOFT LIGHT-BLUE (2+2)35 8096 XRAY SPRING-SET HARD DARK-BLUE (2+2)35 8120 ALU FRONT SHOCK BODY - HARD COATED (2)35 8160 FRONT SHOCK SHAFT (2)35 8220 ALU REAR SHOCK BODY - HARD COATED (2)38 8260 REAR SHOCK SHAFT (2)96 0025 NUT M2.5 (10)96 1025 WASHER S 2.5 (10)96 8070 G-CLIP 7 (10)97 1035 SILICONE O-RING 3.5x2 (10)3580503524603580103580103580809600253580359610253581603581209710353580109680703524603580703580103580953580963580103580113580953580963582203582602811. SHOCK ABSORBERSFRONT SHOCKSLONG shock bodyLONG shock rodDo not overtighten968070G 7971035O 3.5x2960025N M2.5961025S 2.5960025N M2.5961025S 2.5968070G 7971035O 3.5x211.1OILPISTONS DETAIL1.51.41.31.51.41.3STRAIGHT HOLESCONICAL HOLESDOT ON PISTONO-rings Insert G-clipin grooveSHORT shock bodyOILGrip the shock rod at topof exposed threads with sidecutting pliers.Be careful not to damagethe shock rod.SHORT shock rodUse 1.5mm pistons, straight(no dot on the piston)Do not overtightenGrip the shock rod at top of exposed threadswith side cutting pliers.Be careful not to damage the shock rod.step stepstep 2xBAGGrip the shock rod at topof exposed threads with sidecutting pliers.Be careful not to damagethe shock rod.O-ringsUse 1.5mm pistons, straight(no dot on the piston)Insert G-clipin grooveREAR SHOCKS 2xBAGGrip the shock rod at top of exposed threadswith side cutting pliers.Be careful not to damage the shock rod.step stepstep