Menu
Xpand AD025-RF-X1 User Manual
Also see for AD025-RF-X1: User guide
    | |
Contents | 
© XPAND, All Rights Reserved. 3 www.xpand.meEmitter Overview1. Standard VESA connector2. LED Red light indicator (in the shape of an X)Using with 3D TVs and Projectors1. Connect the emitter connector to the corresponding VESA stereo connectorin the TV or projector.2. Once the emitter is connected to the TV/projector, please make sure that theTV/projector is in 3D mode.3. For maximum range emitter should not be placed on the ground/floor butshould be placed at least 10 cm above ground (like on a shelf).The emitter does not require a battery.TroubleshootingThe emitter is connected but the glasses still do not work: Firstmake sure your glasses are turned on and that the TV/projector is in 3Dmode (if the X LED on the emitter is off then the TV/projector is not in3D mode). Also note that 3D RF glasses usually need to go through aso called “pairing” process when using them with a new emitter for thefirst time. Refer to your glasses’ manual for instructions on how to pairyour glasses to a new emitter, TV or projector. If problem persists tryunplugging the emitter for a couple of seconds and then plug it back in thecorresponding VESA stereo connector in the TV/projector.Technical SpecificationsType of Synchronization: Radio Frequency (RF)3D Synchronization Protocol In: VESA Stereo3D Synchronization Protocol Out: FHD3D RF protocolShuttering Frequency: 96 Hz, 100 Hz, 120 Hz, 144 Hz, 192 Hzand 240 HzHigh Frequency Rate: YesConnector Type: Mini-DIN 3 (VESA Stereo)Setup: Plug&PlayCoverage Range: 25 m (82 ft) radius typical, 10 m (33 ft)minimum (distance around the emitter)Power: VESA powered, no external power supply neededOperating Temperature: 5 °C (41 °F) – 40 °C (104 °F)Weight: 76,5 g (2.69 oz)AD025-RF-X1-manual-v2.indd 3 7/15/2014 10:33:20 AM |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved