OneStart

Menu

Xhifi XDC-1 Owner's Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Contents
  1. Table Of Contents
  2. Speaker Types
  3. Confirming Supplied Accessories
  4. Precautions for Installation
  5. Connections
  6. Operation
  7. Troubleshooting
  8. Specifications
Xhifi XDC-1 Owner's Manual Manual pdf 11 page image
XHIFI, INC.465 PIKE ROAD ● UNIT 112 ● HUNTINGDON VALLEY ● PENNSYLVANIA ● 19006-1621 ● USA866-55-XHIFI ● 267-288-0199 ● 267-288-0198 FAXinfo@xhifi.com ● www.xhifi.comPage 11 of 14Connections (continued):• The XDC-1 accepts low-level stereo signal sources, such as home or portable CD/DVD players,mp3 players, computer soundcards, gaming consoles, etc. It will also accept the tape or preampoutput from a receiver or preamp (we suggest the preamp output as it allows for volume control).• Some sources (such as computer soundcards and portable mp3/CD players) only output through3.5mm connectors; for these applications, use of a 3.5mm/2 RCA Cable (included), or a 3.5mm/2RCA Adapter (available through Xhifi) is required.• The XDC-1 employs two different volume controls, one for the subwoofer only, and one “master”for the entire system (consisting of both speakers PLUS subwoofer). If the signal source alsoemploys a volume control, please consider using this when operating the system (see below).• Utilizing a crossover fixed at 230 Hz, the subwoofer divides the incoming signal into two parts,retains the bass portion, then sends the midrange/treble portion to the main speakers. TheXDSW1 subwoofer can be used as a stand-alone subwoofer, but please note that the speakeroutput terminals on the XDSW1 will remain active (for connection to the XD1 Satellite SpeakerONLY).• Make all connections before the plugging the AC power cord into an AC Outlet.Operation• STANDBY/ON lamp (with auto power on/off function) – applicable to XDSW1 Subwoofer ONLYWhen the POWER button is pressed to ON, the STANDBY/ON lamp lights up green. If about 30 minutes elapse with no signals, the modeswitches to the standby mode, and the STANDBY/ON lamp lights red.When audio signals are input, the mode automatically becomes the ON mode, and the STANDBY/ON lamp lights green.ON mode: STANDBY/ON lamp lights green.Standby mode: STANDBY/ON lamp lights red.
/ 14
This manual is suitable for:
XDC-1
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved