Xerox WorkCentre Pro 75 Operator's Manual

Also see for Docuprint 75: Getting started Software guide Planning guide Supplementary guide Software guide

Contents

Xerox WorkCentre Pro 75 Operator's Manual Manual pdf 39 page image

Operator Guide Product overviewDocuTech/DocuPrint 75/90 and DocuPrint 75 MX 3-11StaplingRemoving any of the output while the printer is running mayproduce finished sets that are incorrectly stapled.To ensure that the stapling of thin sets is satisfactory, the printerperforms the following actions.After 30 finished sets of 15 sheets, the printer:1. cycles down2. raises a message to empty the Stacker3. waits until the sets are removed4. raises the Stacker Tray5. cycles up and resumes printing.If these parameters are not satisfactory for your printing, contactXerox.Staple placementFor information about the limitations of portrait and landscapestaple placement, refer to the Staple Placement table below.Table 3-1. Staple placementEdge FeedOrientation Media SizePortraitStapleLandscapeStapleDualPortraitStapleDualLandscapeStapleLong 8.5x11 FAULT FAULTLong 8.5x14 N/A N/A N/A N/AShort 8.5x11 FAULT FAULTShort 8.5x14 FAULT FAULTShort 11x17 FAULT FAULT