q Check off the box after each Step is completed.1. q Remove all paper and the clear plastic PrinterOutput Tray in front of the paper tray. (See Figure 1)2. q Insert approximately a ¼ inch thick stack of20 lb. paper (measure it) into the Paper Tray.3. q Insert the Feed Roll Cleaning Pad (provided inKit) in front of the paper stack (Long-Edge-Down) withthe green side (coarse side) facing out.Page 1 of 2NOTE: Good lighting is required in order tosee inside the WorkCentre 450c / 450cpF¸CUSTOMER SELF SERVICEFigure 1. Inserting the Feed Roll Cleaning Padinto the Paper TrayStep 1:Remove allpaper and theclear plasticPrinter OutputTrayBottom ofPaper TrayPrinter OutputTrayStep 2:Insert approximately a ¼inch thick stack of paperinto the Paper Tray andinsert the Feed RollCleaning Pad in front of thepaper stack with the greenside facing out¼ inch PaperStackFeed RollCleaning Padwith the greenside facing out3 Feed Rolls are infront of the Pad(continued)Xerox - DOCUMENT WorkCentre 450c / 450cpFeed Roll Cleaning KitThe purpose of the instructions is to provide a step by step procedure to correct a paper feed problem. Read allthe instructions before performing this procedure.CUSTOMER PREPARATION:• Unpack the repair kit and read the Repair Instructions.Contents of kit: • Feed Roll Cleaning Pad • Repair InstructionsDRB-FILE709P00850 Rev A March 2000