Xerox Phaser 7300 Quick Start Manual

Also see for Phaser 7300: Brochure & specs Support guide Specification Overview Troubleshooting guide

Xerox Phaser 7300 Quick Start Manual Manual pdf 1 page image

PhaserÆ 7300 Color PrinterCopyright © 2002 Xerox Corporation. All Rights Reserved. 26Output TraysYou can send output to the following trays:To change the default output destination on the front panel:1. With Menus highlighted, press the OK key.2. Scroll to Printer Setup Menu using the Up Arrow or Down Arrow key.3. Press the OK key.4. Scroll to Job Defaults Menu and press the OK key.5. Select Set Paper Destination and press the OK key.6. Select either Top Output Tray or Left Side Output Tray and press the OK key.The output goes to the default tray unless specifically changed in the printer driver.NoteWhen you select the Left Side Output Tray as the paper destination and the Left Side OutputTray is not open, the printer displays an error message on the front panel that the job will notprint until the Left Side Output Tray is opened.Top Output Tray Default output destination. Delivers output facedown. Can be used for paper up to 18 inches (450 mm)long.Left Side Output Tray Delivers output faceup. Keeps the paper flat so is always used for printing onenvelopes, labels, business cards, and other specialtymedia. Must be used when you print on paper that is over18 inches (450 mm) long.7300-1721

/ 2

Related manuals for Xerox Phaser 7300