Xerox DocuPrint 180 System Configuration Manual

Also see for DocuPrint 180: Message guide Quick reference card Quick reference card System guide Getting started

Contents

Xerox DocuPrint 180 System Configuration Manual Manual pdf 67 page image

SETTING THE SYSTEM CONFIGURATIONXEROX DOCUPRINT 96/4635/180 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM 4-9For jobs that contain such high frequency of plex changes, it isrecommended that the Maximum Simplex value be set to 0.This allows the print engine to perform simulated simplexwithout charging for the blank pages.Note: Ideally, this value should be set to the number of dead cyclesrequired to clear the printer’s paper path.3. Click Apply.Rotating the page originIf you want to print a job that was designed for a continuous formsprinter, you can enable the job to print on the cut-sheet IPS printer byrotating its page origin 90 degrees. When you do this, the IPSemulates a continuous forms printer while printing on cut sheets.Example: Suppose you wanted to print a continuous forms jobdesigned for 17 by 11-inch (or possibly A3) paper on your IPS, whichuses cut sheets.• The page or text origin is always in the upper-left corner of theprinted page.• For continuous forms printing, the longest edge (17 inches)is the top edge. (See the illustration below.)For cut-sheet printing, the short edge (11 inches) is the topedge. (See the illustration below.)For the page to print correctly in portrait orientation on the IPS cutsheets, its text origin must be rotated 90 o , via the Continuous FormsEmulation window.