Customer Release NotesEFI Fiery® Color Server for Xerox DocuColor 242/252/260,version 2.0Part Number: 4505949816 April 2007Copyright 2007 © Electronics for Imaging, Inc.This document contains information about the EFI Fiery Color Server for XeroxDocuColor 242/252/260, version 2.0.Before using the EFI Fiery Color Server for Xerox DocuColor 242/252/260, make copies ofthese Customer Release Notes and the Quick Connect Guide and distribute them to all users.N OTE : This document uses the term “Fiery Color Server” to refer to the EFI Fiery ColorServer for Xerox DocuColor 242/252/260. The term “copier” refers to the DocuColor 242/252 and DocuColor 260 copiers.System System software installationIf you install system software from a client computer over the network, and the installationfails because of connection timeout, exit any applications and disable any virus protectionsoftware or pop-up blocker on the client computer.After installing, upgrading, or reinstalling softwareAfter installing, upgrading, or reinstalling your system software, you must reboot the FieryColor Server.Server loses connection or unresponsiveIf you are using an older keyboard and mouse with PS-2 type connector, the Fiery ColorServer may not restart properly or may lose connection. This is caused by PS2-stylecomponents which are not supported. EFI recommends using keyboard and mouse with USBconnector.OS support OS support on client workstationsIn addition to the operating system support listed in Welcome (on User Documentation CD),the following operating systems are now supported: Intel-based Mac, Windows XP (64-bit),and Windows Vista (32- and 64-bit).Intel-based MacSystem requirements• G3 800 MHz• 500 MB RAM• At least 80 MB of hard disk space for installation (500 MB recommended for writing fullpreviews of raster files and handling large PostScript and PDF files).• At least 1024 x 768 monitor resolution