7 Adjustments134 8265/8290/8365/8390 User GuideAt the Control Panel, press either the F2 key or F4 key to select the number determined in the previousstep.Using the previous steps example, you would press either F2 or F4 to until the display read “4”.Step 4 : Press the [Enter] key on the control panel to set the Uni-D Alignment value for “Head 2".Step 5 : Repeat steps 3 through 5 to set the Uni-D Alignment for Print Heads 3 and 4.Step 6 : Repeat step 2 and analyze the Uni-D Test Print. again. Verify that the Uni-D Alignment issuccessful. The test print should look similar to the test print example in Step 3.If necessary, repeat the Uni-D Adjustment until the Uni-D Test Print looks similar to the testprint example in Step 3.
