Xantrex PROwatt SW 700i Owner's Manual

Contents

Xantrex PROwatt SW 700i Owner's Manual Manual pdf 25 page image

975-0525-01-01 17OperationRestarting After an AC Output Shutdown1. Press and hold the unit’s power switch button to turn it Off.2. Remove all AC loads or let the unit cool down for 15 minutes.3. Press and hold the unit’s power switch button to turn it On.Changing the Audio Alarm Setting1. Press and hold the power switch button for five seconds.NOTE: You will hear a beep after holding the button for aboutone second. Keep holding the button for five seconds more tochange the alarm setting.2. Observe the message on the digital display.If you see a.L.1. being displayed, this indicates that the audioalarm is enabled even during warning conditions. If you seea.L.0. being displayed, this indicates that the audio alarm isdisabled.NOTE: Factory setting is a.L.1. .3. Release the button to which setting you want.NOTE: Holding the power switch button continuously for morethan five seconds at a time will cycle the alarm setting to a.L.1then to a.L.0 and so on until the button is released.Operating LimitsPower OutputThe PROwatt SW will deliver the following power continuously,depending on input voltage and ambient temperature. The inverterwill deliver more than 10% of its continuous power rating forapproximately five minutes.Model Poweraa.Applies to resistive loads such as incandescent lights.Current bb.Applies to reactive loads such as motors.Voltage Temp.PROwatt SW 700i 700 W 3 A12.5 VdcAmbient25 °C(77 °F)PROwatt SW 1400i 1400 W 6 APROwatt SW 2000i 2000 W 8.7 APROWatt SW Inverter International.book Page 17 Tuesday, June 30, 2009 9:58 AM