XVision XRN0808E Quick Setup Manual

Also see for XRN0808E: User guide

Contents

Table Of Contents
Introduction
Installation
XRN1609 HDD Install
XRN2016/3625 HDD Install
Connection Guide
Wizard Setup
Network Setup
Adding an IP Camera
Manually Adding A Camera
Manual Add
HDD Settings
Recording Schedule
motion detection
Video Playback
Backup Setting
Device Search Tool
Accessing The XRN/XC via IE
FAQ's

XVision XRN0808E Quick Setup Manual Manual pdf 22 page image

XRN Quick Setup GuidePRO22www.xvision.comSet Pre and Post Recording by selecting the advanced button. as shown in the picture below.The IP camera must support motion detection to use this function.Modify each video channel parameters on the “Motion” interface, as shown below.1. Click “√” in front of “Enable Motion Detection2. Set motion areas, Left click and drag on your mouse to select the motion area, you will be left withsquares as shown below. To remove an area use the right button and drag on your mouse.The motion area us enabled across all the XR cameras by default.5.7.2 Advance Record5.7.3 Motion DetectionPlease Note