XVision X4 User Manual

XVision X4 User Manual Manual pdf 14 page image

User’s Manual14UTP Input (for 4ch & 8ch models only)Short for Unshielded Twisted Pair, which is a popular type of cable. Due to itslow cost, UTP cabling here is used for replacing BNC cabling.There are plenty of UTP connectors positioned on the rear panel of each unit.Next to these connectors places a switch used to enable or disable thisfunction. Each switch (4ch X4/X8/X16 DVR only has one switch and 4ch/ 8chX4/X8/X16 DVR has two) has four DIP switches on it. These DIP switchesare named by numbers; and each number corresponds to a camera. Notethat BNC are alternative methods of access for video input cabling, whichmeans if you chose BNC for Camera 1, than you have to disable its UTPfunction.NOTE: UTP cable transfers not only Video Signal but also power forcameras.3. General System SetupThe X4/X8/X16 DVR allows user to access some general operations throughthe front panel easily. The following subsections introduce the generaloperations of the unit.The regular displayed OSD information and its displayed positions are shownas following figure. The channel title will be displayed on the top-left side ofthe window, either in full screen mode or in multiple channel mode. Thecurrent operating mode, including Call mode, Dome-Control mode, Playbackmode. Freeze mode and Sequence mode, will be displayed on thebottom-left side of the screen. And the date/ time information will be displayon the bottom-right side.Ch4Playback 2005/11/09 PM04:31:22