OneStart

Menu

XTS Video XTS-KBC-100 User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Contents
  1. Warning
  2. Table Of Contents
  3. Introduction
  4. Installation
  5. Stand-Alone mode
  6. RS-485 network
  7. Operating
  8. PTZ-operation
  9. Sequence setup
  10. Keyboard setup menu
  11. Specification
XTS Video XTS-KBC-100 User Manual Manual pdf 10 page image
OPERATINGTurning on the keyboardThis keyboard can control up to 255 connected devices. You can select any one by pressing[CAM] + [ID]+ [ENTER]9VERSION V2.06 LCD shows the keyboard‘s firmware versionand manufacturing dateAfter plugging in the power, the keyboard will start the initialization and self-test. The LC-Displaywill show following message: (for about 2 sec.)MasterLCD shows the current controlling protocoland selected device ID. „Master“ indicatesthat the keyboard is currently set to „Master-mode“After about 2 seconds, the keyboard finishes the initialization and is ready to operate :Select a deviceCAM [ID][ID] can be any number between 1 –255.Please ensure that every device connected to thekeyboard has a valid and unique ID.For setting up the ID, please refer to the operating manual ofeach device.MasterTo setup the keyboard in other controlling protocol, please refer to the section „Keyboard setup“ fordetails.XTS-2 CAM:0012009 / 11 / 05XTS-2 CAM:001 XTS-2 CAM:[ID]
/ 18
This manual is suitable for:
XTS-KBC-100
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved