Menu
XGAMING X-Arcade User Manual
Also see for X-Arcade: Quick start guideManual
           | |
PROGRAMMING THE X-ARCADEThe X-Arcade™ has 4 memory banks. Mode 1 is factory programmed and non-changeable, for usewith MAME™ and other emulators. Modes 2-4 are fully programmable as many times as you want.IMPORTANT PROGRAMMING NOTES:• When the light is on, you are in play mode. When the light is off you are in program mode.• Remember that MODE 1 (switch closest to the serial cable) cannot be programmed.• A keyboard must be plugged into the X-Arcade™ to program it, even if you use the USBconnection.• To change modes, you must slide the switch on the back to desired Mode position, and thenpress the SAVE/LOAD button TWICE to load that mode. (The light on the X-Arcade™ should goout on the first push, and back on with the second)• Programming is for the PC/MAC only, and does not function on game consoles.NOTE: If you want to switch MODES after programming, you slide tothat MODE, then PRESS LOAD BUTTON 2 (TWO) TIMES. Don't forget this step.Remember to HOLD THE BUTTON ON the X-Arcade and KEYBOARDtogether until LED FLASHES1110Programming Instructions:Start by choosing Mode 2, 3 or 4 by sliding the switch away from the serial cable.1. Press the black button (LOAD BUTTON) on the back of X-Arcade™ (the red lightturns off).2. Press and hold any button or direction on a joystick (UP, DOWN, LEFT or RIGHT) on theX-Arcade™ that you wish to change (keep holding during Step 3!).3. While still holding button/direction in Step 2, press and hold a key on the keyboard untilthe light on the X-Arcade™ starts to blink. Once the light starts blinking, the button on theX-Arcade™ has been programmed to the keyboard button selected in step 2. Release the heldbutton/direction and keyboard key.4. Repeat steps 2 & 3 to program additional buttons/directions. (Do not press load again)5. Press the LOAD BUTTON to close out and save your entire programmed mode!You can use a word editor like notepad to verify the programming, your buttons and joysticks shouldnow type the letters you have programmed them to.All of the programmed buttons will be saved permanently in the X-Arcade™’s on-board memory. Ifyou turn off the computer, or unplug the X-Arcade™, the programmed buttons will not be lost. TheX-Arcade™ can be reprogrammed as many times as you like. This hardware based function wasdesigned to allow easy use with any Operating System. You can also just assign keys in each individualgame.Page 16 has 3 blank layouts for you to write your favorite programmed modes 2-4 into. More areavailable for print on the "Customer Service" page of our website www.X-Arcade.com .kljhfjkdjbkjbgjdbgkldbnNOTE: When switching between modes, you activate the MODE bysliding the toggle switch to the MODE, then pressing the LOAD buttonon the back of X-Arcade twice.) Remember, anytime you wish tochange MODE, after you slide the switch, PRESS LOAD BUTTON TWICE!PC & MAC Adapter (Mode 1)84261 2 RD GFA S QW E [6C 5Z X3 4LeftCtrl LeftAlt SpaceLeftShift]Numpad(Numlock ON) |
Related manuals for XGAMING X-Arcade
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved