Menu
Whirlpool WHER12 Installation And Operation Manual
                        | |
Contents
|
Faucet ElectronicsIf so equipped, the Re system will monitor the total product flow of the reverse osmosis system andalso length of time the filters have been installed. The faucet base has an indicator light that flashesto inform you of the status of the Re membrane and filters. This indicator light will flash only whenwater is flowing.• Green - Re membrane and filters are good.• Amber - Warning, pre and post filters will need replacing shortly. Filters need replacing, whenwater has been drawn, after 182 days (or 750 gallons have been used).• Red - Re membrane needs to be replaced.When the two "AA" batteries are first applied at initial start up, the LED indicator light will flash ina red, amber, green sequence. All timers and counters are reset to zero.In order to reset the monitor time and gallon count feature, the batteries should be removed for a mini-mum of five seconds and then reinserted.Batteries need to be replaced once a year at the time of filter replacement. Do not mix battery types,use only "AA" alkaline batteries. Improper placement of batteries could damage electronics. Use carewhen inserting batteries to align them correctly in manifold with the proper polarity.AutomaticShut OffElectronics(monitoredmodels only)Batteries(monitoredmodels only)Figure 1Shutoff AssemblyCheck ValveTo conserve water, the drinking water system has an automatic shutoff system. When the storage tankhas filled to capacity, and the drinking water faucet is closed, pressure closes the shutoff to stop flowto drain. Pressure in the storage tank is about halt" of the water supply pressure. After drinking wateris used, and pressure in the system drops, the shutoff opens to allow water flow again.Flow ControlA check valve (Figure 13) is located in the Re manifold, above the center sump. The check valve pre-vents a backward flow of product water from the storage tank. A backward flow could damage the Remembrane.Water flow through the Re membrane is regulated by the flow control. It maintains the desired flowrate to obtain the highest quality drinking water. The flow control is located in the end of the 1/4" reddrain tubing, at the Re manifold drain port. |
Related manuals for Whirlpool WHER12
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved