Whirlpool W10692945 Installation Instructions Manual

6Electrical RequirementsObserve all governing codes and ordinances.Ensure that the electrical installation is adequate and inconformance with National Electrical Code, ANSI/NFPA 70 (latestedition), or CSA Standards C22.1-94, Canadian Electrical Code,Part 1 and C22.2 No. 0-M91 (latest edition) and all local codesand ordinances.If codes permit and a separate ground wire is used, it isrecommended that a qualified electrician determine that theground path is adequate.A copy of the above code standards can be obtained from:National Fire Protection Association1 Batterymarch ParkQuincy, MA 02169-7471CSA International8501 East Pleasant Valley RoadCleveland, OH 44131-5575■ A 120 volt, 60 Hz., AC only, 15-amp, fused electrical circuit isrequired.■ If the house has aluminum wiring, follow the procedurebelow:1. Connect a section of solid copper wire to the pigtailleads.2. Connect the aluminum wiring to the added section ofcopper wire using special connectors and/or toolsdesigned and UL listed for joining copper to aluminum.Follow the electrical connector manufacturer's recommendedprocedure. Aluminum/copper connection must conform withlocal codes and industry accepted wiring practices.■ Wire sizes and connections must conform with the rating ofthe appliance as specified on the model/serial rating plate.The model/serial plate is located behind the filter on the rearwall of the range hood.■ Wire sizes must conform to the requirements of the NationalElectrical Code, ANSI/NFPA 70 (latest edition), or CSAStandards C22. 1-94, Canadian Electrical Code, Part 1 andC22.2 No. 0-M91 (latest edition) and all local codes andordinances.INSTALLATION INSTRUCTIONSPrepare LocationCAUTION: To reduce the risk of fire and electrical shock, installthe In-Line Smart Kit only with the range hood model series listedin these instructions.■ Before cutting or drilling into the ceiling or walls, make surethere is proper clearance within the ceiling or wall for the ventsystem.■ When cutting or drilling into the ceiling or wall, do notdamage electrical wiring on other hidden utilities.■ Determine which venting method to use: roof, or wall.■ The In-Line Smart Kit must be installed to a secure structureof the roof, ceiling, wall, or floor. The In-Line Smart Kit mayalso be installed into a new or existing frame construction.The structure must be capable of supporting 25 Ib (11.3 kg).The installation holes on the in-line mounting bracket to beused to mount the In-Line Smart Kit to the structure.Prepare In-Line Smart Kit1. Using two or more people, move the In-Line Smart Kit andthe range hood to a workbench or work space.2. Unpack all parts supplied with the In-line smart kit. Use the“Tools and Parts” section of this manual to verify that all partshave been included.3. Remove the In-line-Smart assembly from the woodenpackaging materialNOTE: Do not move the In-Line Smart Kit to the mountinglocation until the range hood blower motor has been installed inthe in-line housing. Do not install the range hood until the In-LineSmart Kit and vent system have been installed.IMPORTANT: Installation of the In-Line Smart Kit is modelspecific. Before installing, determine the model number of therange hood to be used with the In-Line Smart Kit. See theappropriate “Install In-Line Smart Kit” section.A. Distance between installation holes: 24" (61 cm),19½" (49.2 cm), 18" (46.2 cm), and 14½" (36.8 cm)B. Distance between installation holes: 7¾" (19.7 cm)C. Mounting structureCABWARNINGExcessive Weight HazardUse two or more people to move and installrange hood.Failure to do so can result in back or other injury.