Whirlpool W10343071A Use And Care Manual

Also see for WET3300XQ: Instruction manual Energy guide

22First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)to possibly avoid the cost of a service call...In U.S.A. http://www.whirlpool.com/help – In Canada www.whirlpool.caIf you experience Possible Causes SolutionCycle time too short Automatic cycle ending early. The load may not be contacting the sensor strips. Level thedryer.Use Timed Drying for very small loads. Change the Dry Levelsetting on Automatic Dry cycles.Increasing or decreasing the Dry Level setting will change theamount of drying time in a cycle.Lint on load Lint screen clogged. Lint screen should be cleaned before each load.Stains on load or drum Dryer fabric softener not properlyused.Add dryer fabric softener sheets at the beginning of the cycle.Fabric softener sheets added to a partially dried load can stainyour garments.Drum stains are caused by dyes in clothing (usually blue jeans).These will not transfer to other clothing.Loads are wrinkled Load not removed from dryer at theend of the cycle.Select Tumble Press® feature to tumble the load without heat toavoid wrinkling.Dryer tightly packed. Dry smaller loads that can tumble freely to reduce the chanceof wrinkles forming.Odors You have recently been painting,staining, or varnishing in the areawhere your dryer is located.Ventilate the area. When the odors or fumes are gone from thearea, rewash and dry the clothing.The electric dryer is being used forthe first time.The new electric heating element may have an odor. The odorwill be gone after the first cycle.Load is too hot Laundry items were removed fromthe dryer before the end of thecycle.Allow Cool Down cycle to finish before removing laundry fromdryer. All cycles are cooled slowly to reduced wrinkling andmake it easier to handle. Items removed before Cool Down mayfeel very warm.A high temperature cycle was usedor the WASH TEMP control was setto high.Select a lower temperature, and use an automatic drying cycle.These cycles sense the temperature or the moisture level in theload and shut off when the load reaches the selected dryness.This reduces overdrying.No heat Household fuse is blown or circuitbreaker has tripped.The drum may be turning, but you may not have heat. Electricdryers use 2 household fuses or circuit breakers. Replace bothfuses or reset the circuit breaker. If the problem continues, callan electrician.Supply line valve not open. For gas dryers, the valve is not open on the supply line.Incorrect power supply. Electric dryers require 240-volt power supply.Check with a qualified electrician.Dryer not performing as expected (cont.)TROUBLESHOOTIng – DRYER cont.