Whirlpool RIHO User Manual

-24-GB!!!Thanks to the non-porous, smooth surface of the material, dirt will not or will hardly stick to the material.Maintenance can be limited by cleaning the bath after use with a wet sponge or cloth and a liquid cleaner (withoutabrasive material).The repair of small cracks and similar damage to the bath.If you want to repair minor damage, due care is recommended. You may proceed as follows for the same:If there are fine scratches, it will be adequate to use a “chrome and lacquer polisher” (free of solvents and granules). Ifthe result of this is not satisfactory, you may sand off the damage with waterproof sandpaper no. 600 and then withwaterproof sandpaper no.1000. Reprocess with “chrome and lacquer polisher” for a perfect end-result and your bathwill be as good as new.A complete set may be obtained from Riho International bv (Article no.: POETSSET001).You may repair your bath yourself at your own risk.Major damages, deep scratches, holes and even cracks may be repaired and can almost be made to disappear. It isrecommended that these should be repaired by specialised technicians.All Riho baths are made of acrylic ( and supported in the bottom with a chipboard andreinforced with glass fibre polyester.is a plastic and coloured all the way through.The properties of provide the user with the maximum bathing comfort, provided the appropriate installation andmaintenance instructions are duly followed.polymethyl methacrylate)Acrylicacrylic2.0 Riho baths (Whirlpools)Acrylic (PMMA)1.5.8 Dipswitch SettingsThe following dipswitches can be found on the printed circuit board in the electronics cabinetDipswitch 1:On 2 motor systems (2,3 button control)Off 1 motor systems (1,2 button control)Dipswitch 2:On Aero system on.Dipswitch 3:On switch on automatic emptying function.Off switch off automatic emptying functionDipswitch 4:OnNote: In the case of Aero, dipswitch 3 is at On by default.Z1209003.4 GB3.0 MaintenanceVotre revendeur : DUVIVIER sàrl - www.duvivier.lu