Whirlpool GLADIATOR STEEL MODULAR THREE-DRAWER CABINET Assembly Instructions Manual

3Tools Needed:Tools Supplied:IMPORTANT:■ Two people may be required to complete the assembly.■ As you assemble the cabinet, make sure the edges with theholes are facing up.■ If you are assembling the cabinet on the floor, fasten the eightfront corner bolts, two at each corner, after you stand the cabinetupright.1. Place side panel (P1) on a flat, firm surface so that the edge withthe holes is facing up as shown.2. Insert the cabinet top (P2) between the edges of side panel (P1).NOTE: Make sure the edges with the holes are facing up.3. Align the holes and attach the top (P2) to side panel (P1) usingsix internal hex-head bolts (F1) and two ⁵⁄₁₆" flange nuts (F2), forthe two middle holes only, as shown. Do not tighten completely.4. Position side panel (P3) so that the top (P2) is between the edgesof side panel (P3).5. Align the holes and attach the top (P2) to the side (P3) using sixinternal hex-head bolts (F1) and two ⁵⁄₁₆" flange nuts (F2), for thetwo middle holes only, as shown. Do not tighten completely.6. Insert cabinet bottom (P4) between the edges of side panels(P1 and P3).NOTE: Make sure the edges with the holes are facing up and thatthe threaded posts are standing up on the inside of the unit asshown.7. Align the holes and attach the bottom (P4) to the side panels(P1 and P3) using12 internal hex-head bolts (F1) and four ⁵⁄₁₆"flange nuts (F2), for the four middle holes only, as shown.8. Square the cabinet frame. The measurements from corner tocorner should be equal distance.9. Using the hex key (provided), completely tighten the bolts.Measure the frame again to make sure it is still square.Install Leveling Legs or CastersThe Gladiator ® Modular Cabinet is designed to be either stationary orto roll on casters.IMPORTANT: If you decide to install the casters on the cabinet, seethe installation instructions included with the caster kit (provided).To install leveling legs:1. Place the cabinet on its side.2. Screw a leveling leg (P7) into each of the four rivet nuts located atthe corners of the cabinet as shown.3. Stand the cabinet upright.4. If you have not already, fasten the two bolts at each front corner,of the cabinet frame. Completely tighten all the cabinet bolts andnuts.■ ¹⁄₂" Wrench■ ³⁄₈" Wrench■ Phillips screwdriver■ Pliers■ Level■ Tape measure■ Hex keyWARNINGExcessive Weight HazardUse two or more people to move, assemble or installcabinet.Failure to do so can result in back or other injury.P2P1P3P4P3P2A. Leveling legsP4P1P2P3AP7P4P1P6