Menu
Whirlpool GLADIATOR GAWG28KDYG Assembly Instructions Manual
                    |
45. Using Phillips-head screws (F3c), fasten the upper back panel(P4) to the lower back panel (P5) and the lower back panel to thecabinet bottom (P3).6. Tighten all back panel screws completely.7. Starting with the front of the cabinet, and using the Allen wrench(provided), tighten all of the bolts completely.Install ShelvesPlan your shelf heights and install the 2 shelves (P6 and P6m) startingfrom the bottom. The shelves are supported by the metal loops onthe side walls of the cabinet.1. Determine the placement of the 2 shelves (P6—1 shelf withoutmagnets, P6m—1 shelf with magnets).2. Place the shelf in the cabinet so that the long edge with the holes(P6) or the long edge with the magnets (P6m) is toward the frontof the cabinet.3. Tilt the shelf so that one end is higher than the other as shown.NOTE: The higher end of the shelf should be directly above thecabinet loop at the desired height.4. Push the shelf edge down so that the shelf tabs go into thecabinet loops.5. Lift up on the lower end of the shelf so that it is above the desiredcabinet loop and push the shelf down into place.NOTE: Check that the shelf tabs are in place behind all thecabinet loops, as shown.6. Repeat steps 2 through 5 to install the other shelf.A. Push downB. Lift upABA. Cabinet loopB. Shelf tabABP1P3P6P6mP2P1 |
Related manuals for Whirlpool Gladiator GAWG28FVEW
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved