With Trim Kit Without Trim KitCompactor®PRODUCT MODEL NUMBERS OVERALL DIMENSIONSCABINET OPENING DIMENSIONSCUSTOM PANELSCLEARANCE DIMENSIONSGC900QPKGC900QPLGC900QPPGX900QPLGX900QPPTC800SPKTU800SPKTU800SPPElectrical: 115-volt, 60-Hz, AC-only, 15- or20-amp. grounded circuit is required. A time-delayfuse or circuit breaker and separate circuit isrecommended.18" min.(45.7 cm)24" min.(61 cm)A15 min.(38.7 cm)34 " min.(87 cm)3"(7.6 cm)" AB341⁄8"(86.7 cm)24"(61 cm)15"(38.1 cm)23¹³⁄₁₆"(60.5 cm)14⁵⁄₈"(37.2 cm)23¹³⁄₁₆"(60.5 cm)15"(38.1 cm)25"(63.5 cm)15"(38.1 cm)A. Raised panel or decorative trimB. Outer section of panel23¹³⁄₁₆"(60.5 cm)1¹⁄₄"(32 mm)14⁵⁄₈"(37.2 cm)⁷⁄₃₂"(5.6 mm)⁵⁄₁₆" ⁵⁄₁₆"(8 mm)both sidesAB(8 mm)A. Grounded electrical outletmust be a minimum of 3 in.(7.6 cm) away fromsurrounding cabinets ornearby walls as shown. Itcan be placed either to theleft or the right side of theproduct.Panel should be 1/2 in.(13 mm) min. thicknessA. Leave 6 in. (15.2 cm) of clearancespace to the right side of thecompactor in order to remove thecompactor bags.B. Leave 23 in. (58.4 cm) of clearancein front of the compactor in order tofully open or remove the compactordrawer.Flat panel Raised panel Models with handles Models without handlesPanel should be 1/2 to 5/8 in.(13 to 16 mm) thick. NOTE: Athicker panel may need roundedfront corners and a cutout foraccess to the handle.A 7/32 in. (5.6 mm) thick panelis required. This is the samethickness as a standard 1/4 in.plywood or paneling. The outer section of panel must be 7/32 in.(5.6 mm) thick to fit into trim. Design raisedpanel sections using dimensions shown above.Because Whirlpool Corporation policy includes a continuous commitment to improveour products, we reserve the right to change materials and specifications without notice.Dimensions are for planning purposes only. For complete details, see InstallationInstructions packed with product. Specifications subject to change without notice.Ref. 9871676 Rev. C11-16-04