Whirlpool ART 471/A+/7 Instructions For Use Manual

Contents

Always unplug the refrigerator before replacing any light bulbs, then follow the relevant instructions inaccordance with the type of lighting fitted in your appliance.Only use bulbs of the same type, which can be requested from the After-Sales Service and authoriseddealers.Lighting type 1)1. Loosen the screws and take off the lamp cover.2. The lamp has a bayonet bulb and needs to be pulled out, notunscrewed, following the directions of the arrows asindicated.3. After the new bulb has been inserted, replace the lamp coverand wait five minutes before plugging the appliance back in.Lighting type 2)To remove the light bulb, turn anticlockwise as shown in the figure.Wait for 5 minutes before reconnecting the appliance.Lighting type 3)If the product has LED lighting which is in need ofreplacing, contact the After-Sales Service for assistance.LED lights last longer than normal bulbs, they illuminatebetter and are more environmentally friendly10Clean the appliance regularly using a cloth and a solution of lukewarmwater and neutral detergent specifically formulated for refrigeratorinteriors. Never use abrasive detergents. Clean inside the defrost waterdrain outlet on the rear wall of the refrigerator (near the fruit andvegetable crisper drawer) regularly, using the tool supplied with theappliance so as to ensure defrost water is removed correctly (see figure).Before all cleaning or maintenance procedures, unplug the appliance fromthe mains or disconnect the electricity supply.21Connect the appliance to the mains power supply.A beep may be emitted by some models, to indicate that the temperature alarm has intervened: press andhold the button to switch off acoustic alarms. As applicable, insert the anti-bacterial/anti-odour filter intothe fan as indicated on the filter package.Note: after switching on, the refrigerator needs approximately 4/5 hours to reach the correcttemperature for storing a normal fridge load of food.FIRST USEAPPLIANCE MAINTENANCEAND CLEANINGCHANGING THE BULB OR LED (depending on the model)