Whirlpool 8171477 Instruction Sheet

1INSTRUCTION SHEETfor Dishwasher Floor Mounting Kit© Whirlpool Corporation 2000(All Rights Reserved)Instruction Sheet 8171478 6/00wWARNINGElectrical Shock HazardDisconnect power before servicing.Replace all panels before operating.Failure to do so can result in death or electrical shock.Kit Contains:2 Mounting Brackets1 Instruction SheetNOTE: Floor mounting screws not supplied, mustpurchase locally.Instructions:1. Remove two (2) screws from the access panel.See Figure 1.2. Carefully remove access panel and toe panel.3. Position dishwasher in its finished installation position.See dishwasher installation instructions for properinstallation position.Figure 2Install brackets in these locations.Place as far back as possible.5. Mark location of hole on the floor for your lag screws.6. Remove dishwasher and drill two (2) holes.NOTE: Hole drill size will depend on size of lag screwbeing used for installation. Lag screws not supplied.Suggest 1 ⁄4 " lag screws, length determined atinstallation.Figure 1AccesspanelScrews4. Place floor mounting brackets on the inside of theside braces as shown in Figure 2. The floor mountingbrackets must be at least 10" (254 mm) from the frontedge of the side brace.(continued)

/ 4

Related manuals for Whirlpool 8171477