Whirlpool 8171413 Installation Instructions Manual

Water Filter Installation InstructionsFollow these simple instructions for your filter type.Phone:US: 1-866-698-2538Hours of operation:Monday – Friday 8:00 AM – 8:00 PM EST1. Locate the filter in the upper right hand side of the refrigerator compartment.2. If replacing a filter, twist the used filter ¼ turn to the left. The install mark will belined up with the indicator mark located on the filter head.3. Gently pull down on the filter cartridge to remove it from the filter head. Note:there may be some water in the filter and some spilling may occur. To reducethe amount of spillage keep the filter upright and do not tip.4. Remove the filter from the packaging. Remove the filter cap.5. Apply the month sticker to the filter cartridge as a reminder to replace the filterevery six months.6. Life up the install mark located on the filter label with the indicator line that ismolded into the filter head.7. Twist the filter cartridge ¼ turn to the right to lock it into place. The remove markshould be lined up with the indicator line on the filter label.8. Reduce water spurts by flushing air from the system. Run water continuouslyfor 4 gallons (approximately 5 minutes) through the dispenser until water runssteady. Additional flushing may be required in some households where water isof poor quality.Part 8171413 & 8171414Refrigerator Water Filter 8TM

/ 1

Related manuals for Whirlpool 8171413