Whirlpool 400011239758 Instructions For Use Manual

Contents

14BUILT-IN INSTALLATIONVerify the minimum measurements required for correct instal-lation of the appliance. The coffee machine must be installed ina column and the column must be firmly fixed to the wall withcommercially available brackets.• Kitchen furniture in direct contact with the appliance mustbe heat resistant (65°C min).• To guarantee correct ventilation, leave a gap at the bottomof the cabinet (see measurements in figure 1).• Position the rails on the sides of the cabinet as shown in thefigure 2. Fix with the screws provided, then extract themcompletely.Position and fix the lock hook with the four screws provid-ed, as shown in the figure placing it in the centre of thecabinet, flush with the front wall.If the coffee machine is installed over a warmer drawer, usethe top surface of this as a reference to position the rails(fig. 2A).In this case, there will be no surface to rest the rails on andthe retaining hook must not be installed.• Fix the power cable with the clip (fig. 3). The power cablemust be long enough to allow the appliance to be extractedfrom the cabinet to fill the coffee bean container.The appliance must be earthed in compliance with legis-lation.Electrical connections must be performed by a qualifiedelectrician following the instructions.• Position the appliance on the rails, making sure the pinsare correctly inserted in the housings, then fix it with thescrews supplied (fig. 4). If the height of the appliance re-quires adjusting, use the spacer disks provided.• If necessary, correct alignment of the appliance by position-ing the spacers supplied under or at the sides of the support(fig. 5-6).• To lift the appliance in the front (max 2 mm), turn the latchas shown in figure 7.