Whirlpool 30" (76.2 CM) FREESTANDING GAS RANGES Installation Instructions Manual

Also see for 30" (76.2 CM) FREESTANDING GAS RANGES: Installation instructions Installation guide Use & care guide Installation instructions Installation instructions

153. Remove plastic cover from gas pressure regulator cap.4. Turn gas pressure regulator cap counterclockwise with a⁵⁄₈" combination wrench to remove.NOTE: Do not remove the spring beneath the cap.5. Turn over the gas pressure regulator cap and reinstall onregulator so that the hollow end faces out and the marking“LP” is facing the direction shown in the above drawing.6. Replace plastic cover over gas pressure regulator cap.To Convert Surface Burners (Natural Gas to LP Gas)1. Remove burner cap.2. Using a Phillips or Quadrex ® screwdriver, remove the burnerbase.NOTE: Reinstall one of the screws through the range cooktopto hold the orifice spud holder in place while removing andreplacing the orifice spuds.3. Apply masking tape to the end of a 7 mm (⁹⁄₃₂") nut driver tohelp hold the gas orifice spud in the nut driver while changingit. Press nut driver down onto the gas orifice spud andremove by turning it counterclockwise and lifting out. Set gasorifice spud aside.4. Remove the cardboard orifice spud holder shipped in theliterature package in the oven. Gas orifice spuds are stampedwith a number, marked with 1 color dot, and have a groove inthe hex area. Replace the Natural gas orifice spud with thecorrect LP gas orifice spud.Refer to the following chart for correct LP gas orifice spudplacement.LP Gas Orifice Spud Chart for Surface BurnersNOTE: Refer to the Model Number and Serial Number Platelocated on the oven frame behind the top right side of the ovendoor for proper sizing of spuds for each burner location.5. Place Natural gas orifice spuds in the cardboard orifice spudholder.6. Replace the burner base using both screw.7. Replace burner cap.8. Repeat steps 1-7 for the remaining burners.A. Plastic coverB. Gas pressure regulator cap with solid end facing outC. Gas pressure regulator cap with hollow end facing outD. WasherE. Gas pressure regulator capA. Igniter electrodeB. Gas tube openingC. Burner capD. Burner baseABCDSide view beforeSide view afterENG LPNG LPABCDA. Orifice spudB. Orifice spud holderC. ScrewD. Spark electrodeA. LP grooveBurner Rating Color Size ID Number14,000 BTU11,000 BTU8,000 BTU5,000 BTUYellow/OrangeYellow/BrownYellow/BlackYellow/White1.07 mm0.99 mm0.85 mm0.70 mmL107L99L85L70BACDA