Whirlpool 27" W10563341A Installation Instructions Manual

Contents

11B2. Remove center screwRemove center terminal block screw (B).Connect remaining wires4.Place hooked ends of remaining direct wire cable wiresunder outer terminal block screws (hooks facing right).Squeeze hooked ends together and tighten screws. Finally,reinsert tab of terminal block cover into slot of dryer rearpanel. Secure cover with hold-down screw. Now, go to VentingRequirements.BCPlace hooked end of neutral wire (white orcenter) (C) of direct wire cable under center terminal blockscrew (B). Squeeze hooked end together. Tighten screw.3. Connect neutral wire1. Prepare to connect neutralground wire and neutral wireAEBRemove center terminal block screw (B). Remove neutral groundwire (E) from external ground conductor screw (A).EBCConnect neutral ground wire (E) and neutral wire (white orcenter wire) (C) of power supply cord or cable under centerterminal block screw (B). Tighten screw.Connect remaining wires3.Place hooked ends of remaining wires under outer terminalblock screws (hooks facing right). Tighten screws.Optional 3-wire ConnectionIMPORTANT: You must verify with a qualified electrician thatthis grounding method is acceptable before connecting.2. Connect neutral ground wireand neutral wire