Menu
Water Well CKE PW DS3 User Manual
     | |
Contents | 
4 55. Installation of the Mini Water Dispenser1. Remove the Water Dispenser from its packaging.2. Place in an upright position away from direct heat or sunlight.3. Clean the Water Dispenser by wiping down the exterior with soap andclean water. (DO NOT get any soapy water inside the water reservoir)4. Insert your Filter Bottle (see section 6). It is recommended that youflush your Water Dispenser before use, and each time you replaceyour Filter Cartridge. Fill the Lower Container with approximately 2lt ofwater and allow to drain into the Water Dispenser, drain this water viaboth water taps and the quick drain valve situated on the underside ofthe Water Dispenser. Repeat another two times.5. Insert the Upper Container into the Filter Bottle and insert the soakedFilter Cartridge, pour 2lt of water into the Upper Container and discardfrom both the cold and ambient water taps to eliminate any carbondust that may come out of your Filter Cartridge.6. Once water has filled the reservoir tanks and is flowing out of boththe ambient and cold water taps in the Water Dispenser, allow tostand for a few minutes then plug the water dispenser into a wallsocket. Turn on the power switch on the back of the water dispenser.The cooling indicator and the power lights on the front of the waterdispenser will come on.7. Allow the Water Dispenser to stand for a while to reach the optimumwater temperature.6. Installation of the Filter Bottle1. Remove the Filter Bottle from its packaging and wash in warm soapywater, rinse thoroughly.2. Remove the Filter Cartridge from its plastic wrapping and submerge ina bowl of water, allow to soak for at least 30 minutes3. Assemble the Single Check Valve on the underside of the LowerContainer. Remove the nut from the top of the Single Check Valve,insert the silicon tip into the hole on the bottom of the Lower ContainerLowerContainerNutSingleCheckValveImage 1and secure the Single Check Valvewith the nut. (see Image 1)4. Once the Single Check Valve isassembled correctly onto the LowerContainer, insert the Single CheckValve and Lower Container intothe recess on the top of the WaterDispenser.5. Insert the Upper Container inside theLower Container.6. Remove the Filter Cartridge from the bowl of water.7. Insert the Filter Cartridge into the recess in the Upper Container.Press down firmly to ensure a seal on the O-ring.8. Fill the upper container with 2lt of water and allow to filter through,follow steps 5 - 7 in Section 5 if this user manual.7. Cleaning and Maintenance1. The Water Dispenser should be cleaned at least once a month andeverytime you change your Filter Cartridge.2. Drain all water from you Water Dispenser. Move the Water Dispenserover a bucket or sink and remove the quick drain cap situated on thethe underside of the unit. Press the butterfly clip together and removefrom around the Quick Drain Silicone Cap, pull the cap off and allowthe unit to drain completely. Also press down on the taps to ensure allwater is removed from the Water Dispenser.3. Once the Water Dispenser is drained, remove the bottle from theWater Dispenser. Remove the Filter Cartridge from the Filter Bottle(if the Filter Cartridge is to be changed follow instructions in Section6 steps 1 - 2, and discard your old Filter Cartridge) and place in abowl of water to keep moist.4. Clean all the components with a mild detergent and water andrinse thoroughly.5. Re-assemble as per section 5 |
Related manuals for Water Well CKE PW DS3
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved