Warn 74580 Installation Instructions Manual

Warn 74580 Installation Instructions Manual Manual pdf 1 page image

Your safety, and the safety of others, is very important. To help you make informed decisions about safety, we have providedinstallation and operating instructions and other information on labels and in this guide. This information alerts you to potentialhazards that could hurt you or others. It is not possible to warn you about all potential hazards associated with this product, youmust use your own good judgment.CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS INJURY OR EQUIPMENT DAMAGE.READ AND UNDERSTAND ALL SAFETY PRECAUTIONS AND OPERATING INSTRUCTIONS BEFOREINSTALLING AND OPERATING THIS PRODUCT.This guide identifies potential hazards and has important safety messages that help you and others avoid personal injury ordeath. WARNING and CAUTION are signal words that identify the level of hazard. These signal words mean:WARNING signals a hazard that could cause serious injury or death, if you do not follow recommendations.CAUTION signals a hazard that may cause minor to moderate injury, if you do not follow recommendations.This guide uses NOTICE to call attention to important mechanical information, and Note: to emphasize general informationworthy of special attention.WARN INDUSTRIES PAGE 1 75732 A0CautionMoving Parts Entanglement HazardFailure to observe these instructions could lead to minor or moderate injury. Always take time to fully read and understand the installation and Operations Guide includedwith this product.Read installation and operating instructions thoroughly.WARNINGINJURY HAZARDFailure to observe these instructions could lead to severe injury or death. Always use extreme caution when drilling on any vehicle. Make sure that all fuel lines, brake lines, electrical wires, and other objects arenot punctured or damaged when/if drilling on the vehicle. Thoroughly inspect the area to be drilled (on both sides of material) prior todrilling, and relocate any objects that may be damaged. Failure to inspect the area to be drilled may result in vehicle damage, electricalshock, fire or personal injury. Always wear safety glasses when installing this kit. A drilling operation will cause flying metal chips. Flying chips can cause eye injury. Always use extreme caution when cutting and trimming during fitting. Always remove jewelry and wear eye protection. Always use appropriate and adequate care in lifting components into place. Always insure components will remain secure during installation and operation. Always tighten all nuts and bolts securely, per the installation instructions.. Always replace all worn or damaged parts before operating. Never operate this WARN product with damaged or missing parts.INSTALLATION INSTRUCTIONSROCK SLIDERSPart Number: 74580Application: 2007 JEEP JK WRANGLER 2 DOOR