Warn 100918 Installation Instructions Manual

Warn 100918 Installation Instructions Manual Manual pdf 1 page image

©2016 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc. 1 97933B1WARN INDUSTRIES, INC. 12900 S.E. Capps Road,Clackamas, OR USA 97015-8903, 1-503-722-1200, FAX: 1-503-722-3000Customer Service: 1-800-543-9276Dealer Locator Service: 1-800-910-1122International Fax: 1-503-722-3005INSTALLATION INSTRUCTIONSAscent Front BumperPart Number: 100918Application: 2017 Ford Super DutyG E N E R A L S A F E T Y P R E C A U T I O N SW A R N I N GIMPACT AND MOVING PARTS ENTANGLEMENT HAZARDFailure to observe these instructions could lead to severe injury or death• Always take time to fully read the Instructions and/or Operations Guide, and/or Basic Guide to Winching Techniques, in order to understand your winch and its operations.• Always use extreme caution when drilling on any vehicle. Make sure that all fuel lines, brake lines, electrical wires, and other objects are not punctured or damaged when/if drilling on thevehicle. Thoroughly inspect the area to be drilled (on both sides of material) prior to drilling, and relocate any objects that may be damaged. Failure to inspect the area to be drilled may result invehicle damage, electrical shock, fire or personal injury.• Always wear safety glasses when installing this kit. A drilling operation will cause flying metal chips. Flying chips can cause eye injury.• Always use extreme caution when cutting and trimming during fitting.• Always remove jewelry and wear eye protection.• Never lean over battery while making connections.• Never route electrical cables:o Across any sharp edges.o Through or near moving parts.o Near parts that become hot.• Always insulate and protect all exposed wiring and electrical terminals.• Always install terminal boots as directed in installation instructions.• Always use appropriate and adequate care in lifting components into place.• Always insure components will remain secure during installation and operation.• Always tighten all nuts and bolts securely, per the installation instructions.• Always perform regular inspections and maintenance on the plow mechanism, fasteners, cable and related hardware.• Always replace all worn or damaged parts before operating.• Never operate this WARN product with damaged or missing parts.Read installation and operating instructions thoroughly.Your safety, and the safety of others, is very important. To help you make informed decisions about safety, we haveprovided installation and operating instructions and other information on labels and in this guide. This informationalerts you to potential hazards that could hurt you or others. It is not possible to warn you about all potential hazardsassociated with this product, you must use your own good judgment.CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS INJURY OR EQUIPMENT DAMAGE. READ ANDUNDERSTAND ALL SAFETY PRECAUTIONS AND OPERATING INSTRUCTIONS BEFORE INSTALLING AND OPERATINGTHIS PRODUCT.This guide identifies potential hazards and has important safety messages that help you and others avoid personal injuryor death. WARNING and CAUTION are signal words that identify the level of hazard. These signal words mean:WARNING signals a hazard that could cause serious injury or death, if you do not follow recommendations. CAUTIONsignals a hazard that may cause minor to moderate injury, if you do not follow recommendations.This guide uses NOTICE to call attention to important mechanical information, and Note: to emphasize general informationworthy of special attention.