Wallgate PSH-20 Series Product Manual

Contents

Wallgate PSH-20 Series Product Manual Manual pdf 11 page image

Revision 711pipes must be flushed through so as to remove any debris & air locks.WARNING! FAILURE TO CARRY THIS OUT MAY RESULT IN DAMAGE ANDFAILURE OF THE UNIT.• Make the water supply connection to the 15mm connection on the unit waterinlet stop tap on the PSH.NOTE: If a sealing compound has been used on the supply feeds, ensure that itis not overly applied as dislodged particles will cause a blockage that mayresult in possible damage to the PSH water system.• For non-cold water outlet models. Attach the flexible water hose (supplied)to the ½” BSP basin water nozzle on the top of the basin, connect the otherend of flexible hose into the hand wash water outlet.• For models with the cold water outlet option. The basin requires a potable(drinking) cold water supply suitable for human consumption. It is theresponsibility of the installation contractor and end client to ensure the coldwater supply is suitable in all respects for human consumption. Attach theflexible water hoses (supplied) into the water nozzle elbow push-fits on the topof the basin. Connect other end of hoses as follows, viewed from the rear ofthe basin: the LH basin nozzle hose to loop round & connect to the RH cabinetpush-fit elbow, the RH basin nozzle hose loops round & connects to the LHcabinet push-fit elbow.• Waste connection. The basin includes a waste outlet pipe tail connection of 1½” (40mm) size. It should be terminated to a suitable deep seal waste trap(not supplied) located 200mm (Min) below the centreline of the basin wastepipe tail.10.6 Electrical supply connectionNOTE! The electrical connections must be carried out by a qualified electricalengineer in accordance with nationally approved IEE Regulations.• The unit will be supplied with a 1-metre flying lead for connection to the mains‘switched fused spur’ supply.• Earth bonding should be carried out to comply with the Nationally ApprovedRegulations. An earth lead is attached to a common earth plate on the basinfascia, connecting relevant Water and Soap nozzles and Air grille, the free endof the earth lead must be securely connected to the M6 equi-potential earthconnection point protruding from the bottom of the PSH control cabinet.• Control lead connection. With the PSH Control cabinet there are 2 possible