OneStart

Menu

Wahlberg Winch 50 Double User Manual

Also see for Winch 50 Double: User manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Contents
  1. SAFETY INFORMATION
  2. Table Of Contents
  3. TECHNICAL SPECIFICATIONS
  4. INTRODUCTION
  5. U SING FOR THE FIRST TIME
  6. PHYSICAL INSTALLATION
  7. AC POWER
  8. I NSTALLING A POWER INPUT CONNECTOR ON A POWER CABLE
  9. DATA LINK
  10. LIFTING WIRE POWER AND DATA LINK
  11. EMERGENCY STOP SWITCH (OPTIONAL)
  12. LIFTING WIRE POWER
  13. SETUP
  14. DMX ADDRESS SETTING
  15. A DJUSTING LIMIT SWITCHES
  16. A DJUSTABLE PARAMETERS
  17. N ORMAL O PERATION
  18. LED F UNCTIONS
  19. SERVICE AND MAINTENANCE
  20. C HECKLIST
  21. S PARE PARTS
  22. WINCH 50 - CHEAT SHEET
Wahlberg Winch 50 Double User Manual Manual pdf 6 page image
6246.805.201 Date: 2017-09-26Technical specificationsModel: Winch 50 DoubleItem no.: 246.702Dimensions: 1644 × 298 × 445 mm / 64.7 × 11.7 × 17.5 in.(L×W×H)Power supply: 210-240V AC 50-60 Hz.Power consumption: 500 Watt.Power plug: Neutrik powerCON TRUE1 NAC3PXDMX control signal: DMX 512 1990 + DMX512A / 6 channels used.DMX connection: 5 pole XLR, male & femaleOwn weight: 116 kg (255.7 lb)Lifting height: 42 m (137.8 ft.)Lifting capacity: 50 kg (110 lb)Lifting speed: Variable, 0.09-0.45 m/s (3.5-17.7 in/s)Wire fleet: 535 mm (21.1 in)Duty cycle: Maximum 30% at max loadMinimum load: 3.5 kg (7.7 lb)Maximum load: 50.0 kg (110 lb)Noise emission (at 1 m): ~65 dBWeight: 30 kg (66.1 lb)Motor: 230V AC, 0.55 kW 2800 rpmLifting wire specifications:Lifting wire: 6.5 mm 8x19 galvanised steel + 3x0.60 mm2electrical conductors (EN 12385-5, ISO 4344)Maximum lifting wire voltage: 230 VMaximum lifting wire current: 10 AWire current inlet Neutrik powerCON TRUE1 NAC3MPXWire current outlet/plug Neutrik powerCON TRUE1 NAC3FXMinimum breaking load (wire): 21.9 kN (2,233 kg / 4,923 lb)Wire safety factor: minimum 10
/ 29
This manual is suitable for:
Winch 50 Double
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved