Wacker Neuson BS 60-2 Operator's Manual

Also see for BS 60-2: Operator's manual Repair manual Operator's manual Repair manual Repair manual

Wacker Neuson BS 60-2 Operator's Manual Manual pdf 33 page image

Maintenance BS 60/BS 70-2335.7 Storage5.7.1 Drain the fuel from the tank.5.7.2 Start the engine and run it until remaining fuel is used.5.7.3 Remove the spark plug. Pour approximately 30 ml (1 oz.) of clean SAE10W30 engine oil into the cylinder through the spark plug opening.5.7.4 Pull the starter rope slowly to distribute oil in the engine.5.7.5 Re-install the spark plug.5.8 TransportationSee Graphic: wc_gr0014655.8.1 Always shut off the engine and close the fuel valve when transportingthe machine.5.8.2 Make sure the lifting device has enough capacity to hold the machine(see identification plate on the machine for weight).5.8.3 Use the central lifting point (a) when lifting the machine.Always inspect the crane lifting cable for wear, damage, or abuse.Protect the cable from any sharp edges. Do not use the cable if thereare any signs of cut wires, excessive wear, or other defects. Replacethe damaged cable immediately to avoid injury or death.5.8.4 Tie down the machine on the vehicle to prevent it from tipping, falling,or rolling. Lay the machine down flat and tie it to the vehicle at points(a) and (b).NOTICE: Drain the fuel tank as required to prevent fuel leaking fromcap (c).WARNING