INSTALLATION INSTRUCTIONSFalcon Wall WasherModel: TL61W/TL62W/TL63WHeadquarters44 Harbor Park Drive, Port Washington, NYPhone (516) 515.5000 • Fax (516) 515.5050www.waclighting.comWAC Lighting (Shanghai)14 Lane 299, Bi Sheng Road Shanghai 201204Phone (86.21) 3393.3558 • Fax (86.21) 3362.1598www.waclighting.com.cnWAC Lighting - International salesRoom 3207-3208, Building 4,Tian An Cloud Park,ShenZhen, Guangdong 518129www.waclighting.ioWAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. April 22, 2019 1 / 3WARNINGIMPORTANT: NEVER attempt any work without shutting off the electricity.· Read all instructions before installing.· Fixtures are designed for use on WAC Lighting’s track systems. They may also be used on othermanufacturer’s brand of track (consult factory for compatibility).Track rating: Input: 220-240V ~, Current max: 16A, Load max: 3680W.· Suit for dry location, do not install in damp or wet locations.· System is intended for installation by a qualified electrician in accordance with the National Electrical Codeand local regulations.· Light Source is not replaceable. (It should be replaced the whole fixture when the life of light source ends.)· Leave the instructions for users/customers for future reference.Caution:· Please switch off the power before fixture installing / maintainance / accessory exchanging.Ⅰ. Installing on Track1. Ensure the “Power Knob” and Adaptor are parallel, and “Phase switching Knob” is located on the state of“Ⅰ” / “Ⅱ” or “Ⅲ”.2. Make sure the convexity on the adaptor box is at the same side with the slot on the track. Fit the adaptor boxinto the track.Phase switching KnobPower KnobSlotConvexityPhase switch:“Ⅰ” indicate fixture is connect on phase1.“Ⅱ” indicate fixture is connect on phase2.“Ⅲ” indicate fixture is connect on phase3.