Velodyne Digital Drive Subwoofer User Manual

Also see for Digital Drive: User manual Brochure Manual Introduction Bedienungsanleitung

Velodyne Digital Drive Subwoofer User Manual Manual pdf 13 page image

Velodyne Digital Drive User’s Manual Page 8Figure 3: Introductory ScreenSee Figure 3. This the Introductory screen. Notice that as you change settings (such as preset,volume, etc.) this is shown on this screen.You enter setup mode by pressing MENU and entering the code 12345. Upon successful entry of thiscode, the system takes you to the EQ Setup screen, as shown in Figure 4.Onscreen Programming and Setup – OverviewYou are now ready to set up and adjust the onscreen audio settings of your Digital Drive subwoofer.This section provides an overview of the setup process. You will be doing all setup functions with thebuttons of your Velodyne-supplied remote control and seeing the results on your TV screen. Words inall uppercase letters in the setup instructions (e.g., SELECT, MENU, etc.) identify the specific remotebutton to be pressed or selected, or the field on the screen you should be paying attention to. Remem-ber to point the remote control at the subwoofer, not your TV!Use the RIGHT and LEFT directional arrow buttons that surround SELECT to move through the fieldsof the setup screen, and change settings by using the UP and DOWN arrow keys. A screen fieldhighlighted in reverse video indicates your current location on the screen. Holding down the LEFT orRIGHT arrow key causes the remote to repeat and you can then rapidly move through fields to arrive atthe desired one. You should be able to perform most of the setup process by using the four arrow keysand the SELECT button.Following is an overview of the screens you will be using to set up your Velodyne Digital Drive subwoofer.