Velleman CAMTVI7N User Manual

Also see for CAMTVI7: User manual

Contents

Velleman CAMTVI7N User Manual Manual pdf 6 page image

CAMTVI7N/CAMTVI7WN/CAMTVI8N/CAMTVI8WNV. 01 – 18/07/2016 6 ©Velleman nvscrewed too tight to leave the option open to position the lens into thedirection of the desired field of operation. Connect the two wires for an analogue PAL signal; leave themunconnected for a HD 1080P TVI signal. Connect the video connector [A] to a monitor (not incl.) or a sequentialswitcher/quad splitter (not incl.) in case of multiple domes. Connect the power connector [B] to a 12 VDC power supply (not incl.). Set up the desired field of observation by adjusting the position of thelens enclosure [5] in the positioning ring [3]. Manually adjust the zoom [4] and focus [8] with their screws. Thelocation of the screws can be determined by looking at the position ofthe light sensor [9]. Tighten the fixation ring [2] to secure the camera’s position.7. OSD SettingsThere is a small joystick in the camera cable that allows you to adjust thesettings of the camera using an on-screen display (OSD). Press the middle button to access the menu, or toselect an option. Press the up and down buttons to move up anddown in the menu. Press the left and right buttons to modify the menuparameters.In the OSD menu: NEXT/BACK: select this option and press the middle button to go to thenext/previous page of options in the menu. RETURN: select this option and press the middle button to return to theprevious level in the menu. EXIT: select this option and press the middle button to leave the OSDmenu without saving the settings. SAVE ALL: select this option and press the middle button to save allsettings. CAMERA RESET: select this option and press the middle button to resetthe camera to the factory defaults.The OSD menu settings are described in detail below.Refer to the table on page 3.