Vectaire WHHR125DC Installation, Operating And Maintenance Instructions

Also see for WHHR125DC: Installation, operating and maintenance instructions Installation, operating, & maintenance instructions

Contents

Vectaire WHHR125DC Installation, Operating And Maintenance Instructions Manual pdf 5 page image

IMPORTANT: READ THESE INSTRUCTIONSFULLY BEFORE INSTALLATING THISAPPLIANCE!The Vectaire WHHR125DC is designed to be fittedinto the roof space or a cupboard. These diagramsshow the dimensions of the unit and the additionalspace required around the unit to allow for futureservicing and maintenance.The unit must NOT be installed in an area whichdoes not have sufficient access for future mainte-nance.The appliance must NOT be installed in an environ-ment which contains:• Excessive oil or a grease laden environment.• Hazardous gases, liquids or vapours that areflammable or corrosive.• Ambient temperatures above 40°C or below -5°C.• Humidity levels above 90% or a wet environment.Safety and guidance• The electrical installation of the appliance MUSTbe carried out by a suitably qualified, competentperson and all wiring must be in accordance withcurrent I.E.E. Regulations and all appropriatestandards.• The appliance must be connected to a local isolation switch with a contact separation of at least3mm.• The appliance is suitable for 230V - 50Hz singlephase fuse rating of 3A.• The condensation drain must be fitted.• Ensure that external grills are located at least 600mm away from any flue outlet, in accordance withall relevant Building Regulations.• Always ensure ducting is free from blockages before switching the unit on as this may invalidate yourguarantee.• We recommend a minimum distance of 2m between the external air supply inlet and the extractair outlet to prevent cross contamination.• We recommend a minimum distance of 200mm between the appliance and any sharp bends induct work.Installation of the appliance MUST be carried out by a qualified and suitably competent person andshould be carried out in clean, dry conditions where dust and humidity are at minimal levels. The unit isnot suitable for installation to the exterior of the dwelling.Page 5InstallationDimensions