Vaughan Stratfield Installation Manual

Vaughan Stratfield Installation Manual Manual pdf 1 page image

Care Instructions - Read Before Installation- This box contains fragile and valuable goods thathave been carefully packed. Please take utmost carein unpacking the parcel as damage can occur in thisprocess.- Please be sure you have received the correctnumber of boxes i.e. 1 of 2, 2 of 2 etc.- Under no circumstances should the product belifted out by the neck or light fitting.- If you have received any damaged goods or aremissing any part of your order, please contact oursales office as soon as possibleRecycling- Recyclable packaging used, please consult withyour local recycling centre for further information.- Waste electrical products should not be disposedof with conventional household waste. Pleaserecycle all parts when possible.Cleaning InstructionsBrass - all types: Use a soft dry lint free clothBronze, Nickel, Silver & Chrome: Use a dry clothonly, no chemical cleanersGlass: We recommend using a strong alcohol such asisopropyl alcohol. Note: some modern cleaningsolutions can contain chemicals that can leave agreasy film on glass.Gilt Wood: Use a dry cloth onlyCeramic: Use a damp cloth onlyWood: Wax polish i.e. Antique waxAlabaster: Dust with a soft brush or a clean dry cloth.Avoid water or water-based cleaners. Any marks thatcannot be removed by dusting must be cleaned by aspecialist.Lacquered Furniture: Furniture polishCrystal: Damp clothCard/Laminated Shades: Use a Feather duster onlySilk Shades: Gently tap to lift dustNeedlework: Dry-clean-Any decorative parts made from other materialsmust be removed and cleaned separately to avoiddamage - e.g. alabaster.After choosing a suitable location that meets all the requirements ofthe safety information install the unit following the steps overleaf.- Carefully unpack all parts and check for damage or missing partsbefore commencing installation.- Installation of this product must be carried out by a qualifiedelectrician.- Disconnect the electrical supply before installation. Switch off theelectricity at the fuse box by removing the relevant fuse or switchingoff the circuit breaker before proceeding with the installation.- Install should be carried out in accordance with the wiring regulationsand building codes applicable to the country of installation.- Before making any fixing hole(s), check that there are no obstructionshidden beneath the mounting surface such as pipes or cables.- Ensure that the support for the light is of sufficient structural strength and that any fixing screws do notinterfere with the connecting cables.- The unit can get very hot during use. Switch the product off and allow to cool before handling or changingbulbs. .- Ensure adequate ventilation space is allowed between the unit and any object above, in front or to eitherside of the unit. Suggested minimum space is 0.5m above and 0.5m on all sides.- To prevent tarnishing, it is advisable to wear gloves at all times when handling the product.- Mains connector must be a lever slicing connector; with a minimum of 3 terminals; rated to 240v 16A(minimum); conforming to IEC 60998-2-1 or IEC 60998-2-7Safety Information - Read Before InstallationVAUGHAN Installation Guidewww.vaughandesigns.comStratfield Wall LanternWA0364Rev 1

/ 4

Related manuals for Vaughan Stratfield