MAINTENANCE : MAINTENANCE PROCEDURES202.9 673.00 10 D 24-March-2004 41Pan Motor Assembly RemovalParts:22.9661.0664 1 EA ASSY, PAN MOTORTools:Screwdriver, #2 PhillipsTo remove the pan motor assembly:Step 1. Using console or internal menus, run lens as far to the rear as possible.Step 2. Disconnect luminaire AC input cable from power source.CAUTION: Be careful not to damage lens during next step.Step 3. Carefully lay luminaire on its side, ensuring that lens does not come intocontact with any surface. Refer to Figure 2-22.Step 4. At enclosure, remove bottom ventilation cover. Figure 2-21. Refer to“Removing Enclosure Covers” on page 35.Step 5. At pan motor assembly, remove four 6-32×3/8" PPZ screws. Figure 2-27.Figure 2-27: Pan Motor Assembly ReplacementStep 6. Slip belt off pan motor pulley.Step 7. Pull pan motor assembly part way out of enclosure and disconnect sensor andmotor wire connectors. Remove pan motor assembly.CAUTION: Ensure no wire will be pinched between mounting plates before securingreplacement pan motor assembly with screws.Step 8. Install replacement assembly by performing Steps 2–7 in reverse order.Pan Motor Assembly6-32×3/8"SensorPPZ Screw
