VarTech Systems VT213C User Manual

Contents

VarTech Systems VT213C User Manual Manual pdf 16 page image

Panel Mounting Procedure1. Cut and drill the panel (refer to panel mount drawing). Measurements are in inches.Panel Mounting Cutout2. If access to the side of the monitor is not available following installation, attach the power and videocables to the side of the monitor at this time.3. Install the monitor in the prepared cutout.4. Install the lock nuts and washers, supplied with the monitor, behind the holes running along the sidesand top/bottom of the cutout in the panel. Extra lock nuts and washers are provided.MOUNTING INSTRUCTIONSMOUNTING INSTRUCTIONS7.1 Panel Mount Procedure147SectionMechanical DrawingsModel Description Page(s)VT213C 21.3” DiamondVue Chassis Mount Mechanical Drawing 15VT213P 21.3” DiamondVue Panel Mount Mechanical Drawing 16-17VT213R 21.3” DiamondVue Rack Mount Mechanical Drawing 18VT213W 21.3” DiamondVue Wall Mount Mechanical DrawingNote:Use #10-32 nuts for mounting.5. Tighten all mounting nuts evenly to a torque of 24 inch-pounds.ATTENTION: Mounting nuts must be tightened to a torque of 24 inch-pounds to provide panel seal andavoid potential damage. Vartech Systems assumes no responsibility for water or chemical damageto the monitor or other equipment within the enclosure due to improper installation.6. Attach the power and video cables to the side of the monitor if you have not already done so.

/ 18

Related manuals for VarTech Systems VT213 Series