19” Fast Scan Series User Guide 150-062-3-FCC CLASS A STATEMENTThe equipment has been tested and found to comply with the limits for a Class A digital device,pursuant to part 15 of FCC rules. These limits are designed to provide reasonable protectionagainst harmful interference in a business installation. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used in strict accordance with theinstructions, may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measure:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and the receiver.- Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.Shielded interconnected cables and shield power cords must be employed with this equipment toinsure compliance with the pertinent RF emission limits governing this device.Changes or modifications not expressly approved by the manufacturer could void the user'sauthority to operate the equipment.FCC STATEMENTFCC STATEMENT2Section