VarTech Systems DiamondVue VT190C User Manual

Contents

VarTech Systems DiamondVue VT190C User Manual Manual pdf 6 page image

4⇒ VT190R, VT190P, VT190C, VT190W or VT190M LCD Monitor⇒ 5 ft Video Cable⇒ 10-32 Mounting Hardware. (For use with Panel Mount only)⇒ 6 ft RS232 Touch Interface Cable (Optional when touch is installed)⇒ CD ROM with Touch Screen Drivers (Optional when touch is installed)⇒ Users Guide (Printed or on CD)2.2 Unpacking and setting up your displayYour LCD monitor package will consist of the components listed below. Open shippingcontainer and lay all components on a flat clean surface.2.3 What is included with your display2.4 Connecting the Display1. Connect all cables to the computer first. This would include the VGA cable and the optionalRS 232 serial touch screen connection.2. After connecting the cables between the LCD monitor and the computer, plug the powercord into the 115/220VAC power outlet.3. Once the 115/220VAC connection is made, the display is active.4. If your computer was off, turn on your computer.5. Your display should now operate as a normal computer display showing your windows orwhatever video is being sent to the flat panel.Note: If for any reason the display goes blank and gives an “out of Range” or “No Input Signal”,your computer or video source is putting out a signal that is out of range of the LCD’s videoboard. If this happens, reboot the computer or video source and make sure you are inputtingthe correct signal. If the display doesn’t work properly, it may be because:(a) The resolution is to high or low for the LCD.(b) The refresh rate is set to high. Refresh on an LCD is different than a CRT. Set the refresh to60Hz. CRT’s need a high refresh rate to avoid flicker. The refresh rate has no impact onLCD’s.(c) The power source is incorrect.(d) The unit is malfunctioning. If you believe this to be true, disconnect the video cable from therear of the LCD and connect to a known good computer CRT display. If the computerdisplay is working satisfactory and the video is within the appropriate range, then contactVartech Customer service for a RMA number at 800-223-8050.2.5 Signal ConnectionsTo avoid irregular operation and /or damage to the display, please insure correct video is beingsupplied as shown on the following page.