Vaniman V-SIX SE Quick Start Manual

Vaniman V-SIX SE Quick Start Manual Manual pdf 1 page image

V-SIX SE120V25799 Jefferson Ave.  Murrieta, CA 92562  1-800-VANIMAN (826-4626)  www.vaniman.com  sales@vaniman.com10281-02/22 PAGE 1PACKING LIST1 - V-Six SE Dust Collector1 - Power Cord1 or 3 - Port Caps (Dependant on Inlet Plate Model)ASSEMBLY INSTRUCTIONS1. Remove the Unit and other parts from the packaging and check against the packing list above.2. Open the front door of the unit to access the filter compartment cover plate. Remove the four blackthumb screws and remove the cover plate. Locate the wing nut at the bottom of the cartridge filter andcheck to make sure it has not come loose during shipping. Tighten if necessary.3. The V-Six requires a dedicated 120 volt, 15 amp, 50/60 Hz. circuit. Plug the removable power cord intothe socket on the back of the unit. Plug the other end into a wall outlet that will support the electricalneeds, then flip the Main Disconnect Switch on the back of the unit into the ON position. Once the unitis supplied power, confirm on the Control Panel (front of unit) that the red POWER ON/OFF indicatorlight is on solid. If the indicator light does not come on after flipping the Main Disconnect Switch to theON position, check that the Power Cord is properly and securely plugged into the unit and the wall.4. The Air Blast filter cleaning system requires compressed air to operate. Connect a 1/4 inch NPT maleconnector air fitting to the brass female connector located on the back of the unit. DO NOT supplymore than 100 PSI to unit.IMPORTANT SERVICE INFORMATION:SAVE SHIPPING BOX AND FOAM FOR FUTURESERVICE. SHIPPING WITHOUT PROPER FOAMMAY CAUSE DAMAGE TO UNIT