Menu
Van Marcke Luna 50 Quick Start Manual
    |
(Fig. 1)2 & Outside ZoneAll installations must comply with guidelines which are based on azonal concept. The diagram above illustrates this concept and mustbe followed to ensure the safe installation of electrical appliances inthe bathroom. These regulations apply to domestic installations only.Installations must be made in accordance with the current IEE wiringregulations and relevant building regulations. We recommend thatall electrical bathroom products should only be fitted by a suitablyqualified, Part P registered electrician.Thank you for purchasing this product.Please read through these instructions carefully and refer back to them duringinstallation to ensure that your product is fitted safely and that it retains its highquality finish.Please retain this leaflet for future reference.Before installation, ensure the domestic electrical mains supply to which the mirroris to be connected is turned off. Before drilling, ensure that there are no hiddencables or pipes in the wall.NB. These products must be installed with a minimum distance of 150mm betweenthe infra-red sensor switch and any adjacent wall or object to ensure correctoperation of the sensor.Mounting Points Diagram (Fig. A)Illuminated MirrorsLuna 50 Art No. 221100 / Luna 60 Art No. 221101Luna 90 Art No. 221102 / Luna 120 Art No. 221103Luna 140 Art No. 221104InstallationEnsure the domestic electrical mains supply to which the mirroris being connected is turned off.1. Position the mirror in a suitable location (according to thezonal diagram - Fig. 1), ensuring that the domestic electricalmains supply is within reach of the electrical entry point of theproduct.2. Carefully mark the position of the mirror using a soft pencilensuring it is level. Remove the mirror and mark the mountingpoints. Please ensure that all marked mounting pointsaccurately match up with the fixing points on the mirror.3. Using a suitable drill bit, drill holes in the marked positions toa suitable depth. If drilling through tile, use a ceramic drill bit.4. Insert wall plugs level with the surface of the wall. If fittingto a tiled surface, wall plugs should be inserted below thetile surface to avoid cracking. NB. For plasterboard walls,specialist fixings should be purchased, available from any DIYor hardware store.5. Screw supplied fixings into wall plugs.6. Connect the domestic mains supply to the terminal boxaccording to the wiring diagram overleaf (Fig. B).7. Hang the mirror in position.8. Switch the domestic electrical mains supply for the mirrorback on.Operation InstructionsTo switch on/off slowly move your hand past the sensor.To alter the colour temperature of the mirror, hold your handby the sensor, the colour temperature will start tochange. Simply move your hand away from the sensor when thedesired colour temperature has been reached and continue tooperate the mirror as normal - the chosen colour temperaturewill remain even after power is switched off and on again.Care InstructionsDo not use abrasives or solvents when cleaning this product.Wipe off all water spillages as soon as possible using a soft, dampcloth.mounting pointsREAR VIEWHanging PortraitHanging landscapeWEEE complianceMust not be mixed with general household wasteThis product is suitable for installation in zones:ENliveear thneutralMAINS SUPPLYLUMINAIRELi ve supply can be R ed or BrownNeut ral supply can be Blue or BlackEarth supply is Green and YellowLi ve is BrownNeut ral is BlueEarth supply is Green and YellowWiring Diagram (Fig. B) |
Related manuals for Van Marcke 221100
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved